Y-Rod Mount for Original Prusa i3 Mk 3

thingiverse

I think the Original Prusa i3 Mk 3 deserves better Y Rod mountings than the stock "clip-in and cable tie down" type. So I designed these. The top of the mount has to be quite thin in order for the Y Carriage to pass over it but there is still plenty of room with my design and the Y Rods are held firmly in a fixed position. Printed in Prusa Orange PETG. Print as the STL with the two smaller holes uppermost. Run an 8mm drill bit through each mount by hand to ream out the main hole. The mounts will then slide on to the rods with a little persuasion leaving them in the correct fixed position without possibility of movement.