"Y" Split for 3/4 to 1/2 inch conduit

thingiverse

Sometimes you feel like a split, sometimes you don’t. This is a “Y”-Split for 3/4 to two 1/2 inch conduits. Why would you use this? I have no idea. I just thought it was an interesting concept. Offset: 15mm Angle: 30 degrees Run Length: 62mm Overall length: 102mm Finished weight: ?? grams Note that the ‘straight’ sections on either end only 16mm long. Normal 1/2 conduit fittings have a depth of 22.5mm. The 1/2 PVC conduit outside diameter is supposed to be 21.33 mm. Because of the expansion/shrinkage of the printing process as well as the ribbed nature of 3D printed parts, I found a 22mm inside diameter was needed for the socket end to slip over a standard conduit. If it comes out a bit loose then I suggest increasing your extrusion factor by a couple of percent. If it comes out a bit to tight then reduce extrusion factor. This is a variation of my design for a “S” bend for 1/2 inch conduit: https://www.thingiverse.com/thing:2958303