YA Google Fiber Router Wall Mount - GFRG210

thingiverse

Yet another Google Fiber Router wall mount! ## __Inspiration__ Looking for a way to wall-mount my Google Fiber Router box (GFRG210). Took inspiration from thing [Google Fiber Router Wall Mount](https://www.thingiverse.com/thing:1447260) designed for the GFRG100. Sure I could have scaled that one up a bit to fit mine, but unfortunately I had a few additonal requirements that meant I needed to start from scratch. ## __Requirements__ 1. Wanted to mount mine with 'wires down' so that could mount it above the network rats nest. This required adding openings for the various wires possible to plug into it. 2. My printer can't print longer/wider than 180mm reliably (GFRG210 is 203mm x 205mm or 8"x8") so had to split it into left and right pieces. This then required adding additional screw holes for additonal support. 3. Wanted screw holes to be flush mounted so that router doesn't get scratched. 4. Needed to accomodate the feet under the router. 5. Needed to add front holes to permit screwdriver access to the screwholes. 6. Wanted a snugger fit and slightly thicker material to provide additional support. This meets all my requirements. ## __Printing Instructions__ I printed it with 0.2mm layer height in PLA with 0.8mm wall thickness, 2 wall line count, 0.6mm top/bottom thickness, 30% infill. Used zig zag full support. I oriented the part on the build plate with long side flat on the bed, so supports are minimal. Print time 3hr 20min per side piece. __BE SURE to rotate the part in your slicer prior to printing to minimize supports__