YAESU FT-891 Anderson PowerPole Power Connector Replace

thingiverse

My power connector got loose from living in my backpack most of the time. Since i don't like the stock Molex connector anyway i did this remix. It is rock solid. ### Printing Instructions Print the outer part twice. One as it is and one mirrored. There is a mirrored STL meanwhile, just in case. The outer part needs support. I used tree support. I used PLA at 0.2 mm Layer height, but you probably can use any Material ### Installation One video says more than a thousand words, so: Thanks K8MRD <iframe width="560" height="315" src="https://www.youtube.com/embed/rxDtu-lwrtk" title="Yaesu FT-891 Anderson Power Pole Replacement Modification" frameborder="0" allow="accelerometer; autoplay; clipboard-write; encrypted-media; gyroscope; picture-in-picture" allowfullscreen></iframe> Thank you KD8YIX: <iframe width="560" height="315" src="https://www.youtube.com/embed/aT-YCLHJpvA" title="YouTube video player" frameborder="0" allow="accelerometer; autoplay; clipboard-write; encrypted-media; gyroscope; picture-in-picture" allowfullscreen></iframe> ** Note ** you should check out the youtube channels of these guys. ### Upcoming I am very well aware of the fact that this remix is far from perfect. This is what i am going to improve: - Add a threaded insert version - Adjust, so the gap between the outer parts does not look that ugly - Improve Printing instructions, especially support wise. ### Troubleshooting If you are experiencing any problems, do not hesitate to contact me. Either via email (qzr. com, my call is DG7PX) or just comment. ## History - 09/04/2022 Added outer Part Mirrored by request - 07/28/2022 Initial Upload