Yaesu SMAJ to SMA antenna adapter sleeve

prusaprinters

<p>Graduating from a Baofeng BF-F8 (UV-5R variant), to a Yaesu FT-1XD, I was faced with repurchasing quality antennas for it. With this adapter and a Male-Male SMA adapter, you can use the SMA-Female (often refered to as "J" style) antennas designed for the Baofeng on the Yaesu. I suspect this will work with most other Yaesu radios as well, but have not tested any. Feel free to customize as you see fit.</p> <p>Tip: print just a 5mm height section to test-fit until you have the extrusionSquish parameter dialed in for your printer.</p> <h3>Print instructions</h3><h3>Category: Electronics Summary</h3> <p>Graduating from a Baofeng BF-F8 (UV-5R variant), to a Yaesu FT-1XD, I was faced with repurchasing quality antennas for it. With this adapter and a Male-Male SMA adapter, you can use the SMA-Female (often refered to as "J" style) antennas designed for the Baofeng on the Yaesu. I suspect this will work with most other Yaesu radios as well, but have not tested any. Feel free to customize as you see fit.</p> <p>Tip: print just a 5mm height section to test-fit until you have the extrusionSquish parameter dialed in for your printer.</p> <h3> Print Settings</h3> <p><strong>Printer Brand:</strong> Printrbot</p> <p><strong>Printer:</strong> Simple White</p> <p><strong>Rafts:</strong> Doesn't Matter</p> <p><strong>Supports:</strong> Doesn't Matter</p> <p><strong>Resolution:</strong> 200 microns</p> <p><strong>Infill:</strong> 100%</p> <p><strong>Notes:</strong></p> <p>Set to 10 shells so all paths are concentric</p>