Yellow Submarine

thingiverse

A model based on the yellow submarine I have provided it in split for support-less printing, as well as full (needing support) Not a perfect replica, but I am looking to make a small model. Modeled in Sculptris Instructions Scale as desired, (small will hide my lazy modeling) the split model will need to be glued together Personally I prefer ABS for these situations, as ABS acetone glue-ups work really well for me. I have put both halves on the same build plate to allow scaling at one go. my print was scaled down slightly split model ABS .15 slice 10% infill 80mm/sec a few pinholes at these settings glued with abs/acetone mix (syrup viscosity) filled in holes by dabbing on the goop, set for 10 seconds wipe off with a paper towel (repeat where needed)