Yet Another Mosfet mount for the Anet A8

thingiverse

Another Anet A8 mosfet mount. I wanted to design my own using my editor of choice called OpenSCAD [1]. The design file is attached. The entire design is fully parametrised so you can simply change a variable at the top of the file and the design will rebuild accordingly. I have included two stl files for the mosfet board to be mounted either vertically or horizontally; to do this only requires swapping two variables around: mosLctrs and mosWctrs. UPDATE 18/05/2017 - Don't make the mistake I did. The gap between the Mosfet board and the Anet board's SD Card was so small I couldn't get the card in our out! I have re-done the STL files and the OpenSCAD so there is a much bigger space. If you mount your Mosfet below the Anet Mainboard however, then this won't be a problem. The through-holes are for 3mm cap-head screws (~20mm in length). The base of the bracket has clearance holes to accept the entire cap head end of the screw so the bracket should sit flush on the Anet frame. The look is based on the two remix links above. Thanks for the ideas. I hope people like the OpenSCAD version. If you have a different mosfet board with the mounting centres in different places this is the design file to start from. [1] http://www.openscad.org/