z-axis top stabilizer

thingiverse

This is a modification of the z-axis top holder for the Prusa i3 Original. The design is based off of the original mount for the i3 with 8mm smooth rod and 5mm thread. It is a tight fit with the smooth rod but is loose enough with the 5mm to allow movement. I was having problems with prints shifting the higher the print and noticed that there was a significant wobble within the z-axis rods. since installation prints have gone very smooth Print Settings Printer: Prusa i3 Original Rafts: No Supports: No Resolution: 0.16mm Infill: 100 Notes: Print with your settings or you can print with mine. I typically print at 210C for the extruder and 60C for the bed with fan always on at 40mm/s speed (infill and perimeters) Custom Section