Zastavans Plant Waterer Soda Bottle Attachment

cults3d

Basically its an attachment that replaces the cap of a standard soda bottle with a watering can style attachment. Its important that you print the seal without infill and in TPE. It must be flexible enough to actually be a seal. You can also use your own gasket seals or O rings if you have them, of course. The bottom part with the threads should be printed at 0.1 layer height give or take, to get the best fit with the soda bottle. The top can be printed at 0.2 or whatever you want.The bottom part should be printed with the threads facing up aswell. In order to fit the two parts together you must use superglue or some other glue.Just apply a liberal amount on the bottom part and the top part and force them together. It worked for me and is water tight enough to not leak during use. This was more of a fun project than anything to me!