BigTreeTech & FYSETC Mini 12864 display case

thingiverse

This is my attempt to make case for BigTreeTech Mini 12864 display (same specifications as FYSETC 12864 Mini 2.1). I have designed this case as nice minimal case with small filament usage. All ports are easy accessible and EXT connectors are marked on backplate. Reset button is little bit recessed in body to avoid unintended reset of printer, but accessible by bare finger. Mount system is same as in my Bigtreetech TFT24 Case. It is 18mm wide, so it fits almost any aluminium profile used to build printer frame. You can use it on 2020, 2040, 3030 or any profile with at least 5mm wide slot. There are many variants of main box - for top mount, bottom mount, top & bottom mount and without mount at all (for easier remixes). Every variant is prepared in Normal and Cyberpunk look. These are different only in some engraving on display face. Rear cover is in two variants - one with sharp edges and one with chamfered edges for better look Select variants, that fits your needs. You will need to print one Mini12864_YOUR_VARIANT, one Rear_Cover_Variant and one Panel_Holder. Hardware used: 4x M3x8 HEX head screw - main case screws 4x M3x4x5mm brass insert (optional for case screws, they are designed to tap into plastic case - not needed if you don't need extreme stiffness) 2x M3x16 HEX head screw - mount screws (swivel mechanism) 2X M3 nut (nyloc nut prefered) - for mount screws (swivel mechanism) 2x M5 screws and nuts for your printer frame (M5x10 and T-Nuts for aluminium profiles)