Ender3 V2 auto-power off case

thingiverse

Ender3 V2 auto power off bouton case. I did not invent this thing I modified the thing made by mojama for his Creality Ender 3. I am not sure how to link his thing or remix it, for some reason it is not working. You can find him on Thingiverse or Youtube https://www.thingiverse.com/thing:4343696 https://www.youtube.com/watch?v=4wE3tBhoiWs Parts list: -2x M4 12mm screws -2x M4 hammer head nuts -40cm 18G electrical cable -ON-OFF Switch (Make sure the switch is rated for the Voltage and Amps that your machine works on in your country.) (I used a 250V 3A) I live in Canada and our outlets are 120V. Be safe when working with electricity. How to Install: -Unplug your Printer from the outlet. -Remove both screws form the power connector and pull from the casing -Very gently. Take a small flat screwdriver and press inwards on the plastic wings holding the printers power ON-OFF switch and pull from the casing. -Remove the small cable that goes from the power connector to the power ON-OFF switch -Connect the AUTO Power switch where the small cable was installed and heat shrink the connectors. -Push the power ON-OFF switch back into the casing -Push the power connector back into the casing and screw into place. -Insert the cable in the the aluminum profile neatly -Instal the 3D printed casing and adjust to the appropriate placement. End G-Codes: To prevent damaging the printer add M104 S100; Set Hot-end to 100C G4 S60 ; Wait 1 minute to cool down Place this before G1 X0 Y235 ;Present print I hope this helps. There is a lot of variant designs out there. This is the one that I used because I already had all the parts to do it and I wanted it to be out of the way and somewhat discret. Look at ideas, modify, make things and share. Happy making. Louis