Zelda - The Wind Waker Baton with Sound Effect

pinshape

This design of the Wind Waker Baton is hollow to add a circuit that plays the wind songs every time the tip of the baton faces upwards. The Adafruit Audio FX Mini Sound Board is used to add the sound effect. A detailed instruction for this project can be found in the Assembly Guide.pdf Size ca. 37cm x 9.5cm x 3cm Electronic Parts Adafruit Audio FX Mini Sound Board Mini Metal Speaker Adafruit Mono 2.5W Class D Audio Amplifier Lithium Ion Polymer Battery Tilt ball switch JST-PH 2-Pin SMT Right Angle Connector or use one end of a JST-PH Battery Extension Cable - 500mm Adafruit Micro Lipo - USB LiIon/LiPoly charger Tools and Supplies solid core wire heat shrink tubing and insulation tape soldering iron and solder micro USB cable Wind Waker songs sound les hot glue and hot glue gun superglue or any other strong glue/epoxy you like 4 round magnets (3mm X 3mm X 6mm) (neodymium magnets with a grade N42 should be more than strong enough)  sandpaper and/or files 3D printed Wind Waker parts Print Settings All long parts are designed to fit diagonally inside a 150mmX150mm print bed  Use 80%-100% infill for enough strength  Support is needed for all parts except the staff halves  Print slow and with small layer height (0.1mm) to achieve good detail and surface finish, especially if you do not want to post process the parts Let me know if you have any questions. Updates Added a thinner version of the shaft. Added a Adafruit LiIon/LiPoly Backpack and slide switch (Adafruit LiIon/LiPoly Backpack, SPDT Slide Switch)