Zelda Twilight Princess Small Key

thingiverse

Small key prop from the Legend of Zelda: Twilight Princess. Modeled visually, so it's relatively accurate, but shortcuts were taken. ;-) Like the one in the game, has a loop for a lanyard or cord on the back. Prints about 5.75 inches long at 100%. Enjoy! Note: there are two versions. The screenshots I have of the game aren't clear, so each has a slightly different cord loop- take a look and print your preference. Print Settings Printer: Monoprice Select Mini 3D Rafts: Yes Supports: Yes Infill: light (about 20%) Notes: Printed in Hatchbox silver PLA. I printed mine at 100%, which meant printing it at a 45 degree angle on the Monoprice. (Darn small printbed.) Sadly, this may not print flat easily, as the ring around the key shaft is slightly wider than the handle. Temps: Printed at 190 C on a 50 C printbed, and had a couple of the supports fail but the print came out fine. Good luck!