ZOHD Dart FC and Battery Mounting Plate with GPS Shelf

thingiverse

<p>Replacement Flight Controller Mounting Plate and Battery Holder for the ZOHD Dart and Matek F411Wing. This component is designed to hold a 1400mah - up to a 2200mah lipo battery (if used in combination with my <a href="https://www.thingiverse.com/thing:4325677">Runcam Hybrid Mount</a>) without the need to add extra ballast. The factory fitted weight in the nose should however not be removed.</p> <p>On my design I made use of the 2 Soft Serial firmware for the matek F411 so that I can divide up the available UARTS as follows:<br /> UART1: SBUS RX<br /> UART2: GPS<br /> SOFTSERIAL 1 (ST 1): Smart Port<br /> SODTSERIAL 2 (LED): Smart Audio</p> <p><u>If you found this useful, please consider to buy the needed parts through my affiliate link (or make any purchase at the website below after visiting these links)</u>:</p> <p><b><a href="https://www.banggood.com/custlink/Dmmv2MkQ9n">Matek F411WING</a></b> This Flight Controller will fit on this plate<br /> <b><a href="https://www.banggood.com/custlink/333mUMUblr">Matek GPS receiver</a></b> GPS receiver that I used and originally designed this holder for. It is small, but in my experience not anything special. Just get the cheaper GPS receiver below when the price of this unit is too high.<br /> <b><a href="https://www.banggood.com/custlink/3KDvkkzsjq">Generic GPS receiver</a></b> For new builds I would recommend this GPS receiver. It is pretty fast to lock, and I have been using it for 3 years without any trouble. Had up to 28 satellites connected with Galileo enabled<br /> <b><a href="https://www.banggood.com/custlink/3mDGUqkNn7">Dual Lock</a></b> I highly Recommend to use this to attach the lipo battery to the plate in addition to a velcro strap. This stuff has the strength to hold on the battery during tight turn and some negative G's<br /> <b><a href="https://www.banggood.com/custlink/3DvvUMUZAS">Hex M2 8mm Self Tapping Screws</a></b> - Make sure to get a whole variety of these screws. They are neat to use with 3D printed parts and I use them on all my designs