ZoneStar Z9V5 Purge chute and nozzle clean

thingiverse

Purge chute and nozzle cleaner for Zonestar Z9V5. Attach to the top on the left front side. In the slot you can place a peace of silicone, plastic or metal (be carefull of the size because it can damage the nozzle) to wipe the nozzle as it passes. You can use any brass brush that fits the slot. The code makes sure the sensor and the cooling don't go that far. Included my G-Code for extruder (s) start. ;EXTRUDER START G-CODE M211 S0 ; Turn off soft stops G0 X1 Y-17 F6000 ; Go to X1 Y-17 at 100 mm/sec G92 E0 ; Reset extrusion distance on new tool G1 E50 F90 ; Extrude 50 mm of filament at 1.5 mm/s G92 E0 ; Reset extrusion distance G1 E-3 F90 ; Retract 3mm ;CLEAN THE NOZZLE G0 X25 Y-12 F6000 G0 X35 Y-12 F6000 G0 X35 Y-14 F6000 G0 X25 Y-14 F6000 ;Full turn G0 X25 Y-12 F6000 G0 X35 Y-12 F6000 G0 X35 Y-14 F6000 G0 X25 Y-14 F6000 ;Full turn G0 X25 Y-12 F6000 G0 X35 Y-12 F6000 G0 X35 Y-14 F6000 G0 X25 Y-14 F6000 ;Full turn ;NOZZLE CLEANED G0 X1 Y-17 F6000 ; Go to X1 Y-17 at 100 mm/sec 211 S1 ; Turn on soft stops G92 E0 ; Set current extruder position to 0mm G0 F10000 ; Increase feed rate before next travel M300 ; Beep to signal print start ;EXTRUDER END G-CODE G92 E0 ; Reset extrusion distance G1 E-5 F5000 ; Retract 5 mm. It can go to 100mm depending on color and meterial G91 ; Switch from absolute positioning to relative positioning G1 Z1 F1000 ; Lift nozzle by 1 mm in relative positioning mode G90 ; Return to absolute positioning G92 E0 ; Reset extrusion distance on old tool I use the same G-Code for all extruders. But it can be costumized for each if you use different materials. Fell free to modify and/improve both the purge shute and the G-Code.