rp 1 charging handle 3d models

Please don't use this on a real firearm this piece is put under stress during normal utilisation and was not tested, nor approved, for such use. This is an accurately dimensioned RP-1 charging handle for AK, made by Zenitco. The Necked version is...

A 3-piece replica of a Zennit RP-1 AK charging handle extension, includes the fusion files with the charging handle model I used to cut out the internals To ensure a good fit in the charging handle, heat the handle enough to melt the PLA with a...

Be advise, this model was tested on E&L aks74u essential AEG replica and with LCT RP-1 enlarged charging handle and may not fit on other E&L series or other RP-1 manufacturers, if you tried it on other replicas or manufacturers and find that it fits...

v1 is for the W&S full travel BCG with short stroke recoil guide v2 is for the W&S full travel BCG with long stroke recoil guide For the two grooves, use a generic M4 nut and reuse the set screws provisioned by the LCT RP knob.

First prototype of my RP-1 ish charging handle for airsoft AK Slot for M3 Screw

Multi-use handle. ... Rohde RP-20.200.63

Clean 3D model based on 3D scanned real Remixem RP handle.

latch for AR charging handle

RONI HANDLE CHARGING - CAA G1

Charging handle by cyma replicas

Just a G39 charging handle

Glock charging handle slide plate for MCK. ...Uses a 1/4-20 threaded hole to attach a handle.

charging handle for E&L replicas

charging handle for MP9 KWA AIRSOFT

charging handle ak cyma cm-520

A remix of Barrel1's charging handle

A remix of Barrel1's charging handle

Screwless charging handle for AAP-01

Extended charging handle for Ruger PCC Carbine. ...

Charging handle for airsoft M249/Mk46

... the orientation the files are in with tree supports. Please read the readme file for details. You can get a zip version with everything in it here: https://odysee.com/@BrewNinja:4/ARK_Charging_Handle:4 V1.1 uploaded to fix correct print orientation

... files are in with tree supports. Please read the readme file for details. You can get a zip version with everything in it here: https://odysee.com/@BrewNinja:4/ARK_Charging_Handle:4 V1.1 Uploaded to fix wrong print orientation in the handle file.

This fits over the stock Remi 597 charging handle.

Same as the original charging handle, just a little longer.

original charging handle for the vz61 submachine gun

my kids broke the charging handle on their Xshot 06 gun , so rather than throwing it away ,i just designed a new charging handle.

Charging handle latch for AR15, M4 or M16 modeled to look like the latch in MW3

This is the stock charging handle for the Stribog.Has not been printed yet

Built based on Madplanet's "G39/G36 charging handle" (https://www.thingiverse.com/thing:3752448)

CAA MCK (gen 2) charging handle to fit Brownells RMR cut slide for Glock (17/19)