tight radius tubing bender 3d models
212636 3d models found related to tight radius tubing bender.thingiverse
... BENDER. Actually a real tubing bender doesn't come close to bending a radius as tight as these "things". Printed in PLA / no supports / flat on table. Since I'm not much on building puzzles... ...Some Hints...Vise grips, board, stop block
thingiverse
Simple 8mm (~5/16) tubing bender I whipped up for a homebrewing project. 50mm radius. ...Might want to print with a few walls to make sure the cheeks are strong.
thingiverse
**Pipe Bender for 4mm Tubing** Radius: 10mm Maximum bend: 180° The center guide is split in half because this results in a more symmetric finish when printed. I suggest printing this part at 0.12mm layer height or lower (obviously you'll need two).
thingiverse
a bender for 3/16 tubing, intended for brake line but would work for any tubing the correct diameter made to use #10 machine screws as pivots / handle retainers, and 1/4" tubing a handles chose #10 as you will need to drill through the handle tubing...
thingiverse
I needed a simple tubing bender for small copper pipe and brake lines. I created this in Fusion 360, and it will bend metal tubing up to 0.5in in diameter. Simply grab the tool with your hand and use the other hand to wrap the tubing around the ring....
grabcad
Tubing bender dies Small dies for 1/2 3/8 and 1/4 tubing in 4 sizes of radius dies.
thingiverse
... the hex heads. Could be used as a large radius bender by removing the outer 2 pulleys. ... I'll try and get some other diameter pulleys uploaded as well (5/16", 1/4", 3/16") Updade 2020-02-01: Added 3/16", 1/4", 4mm, 6mm, and 10mm pulley files
thingiverse
... clips. I start by wrapping the center of my length of wire around the round head at the top of the bender, then bend the legs. When I put the clip on the cage I bend the legs closed just enough for it to stay put. ...So far this seems to work well.
thingiverse
Tube bending guide for bending 4mm brass or aluminium tubing usually used in model engine fuel tanks
thingiverse
Remixed for 1/4" OD Copper Refrigeration tubing. Customized version of https://www.thingiverse.com/thing:1680823 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=1680823
thingiverse
Needed a bending tool for Primochill 1/2" PETG tubing (12.7mm) so I designed one in Fusion similar to the 90deg one in the previous post. Fusion makes this simple.. I print with PLA+, on end, not on its flat side -- to have the cleanest print...
pinshape
Tight 45 degree curve, just enough to allow a 3-car train to get around a 180 degree (4 printed sections). Useful for creative layouts that lack space for normal radius corners. I got the idea from a commercial cross-track that included switches...
grabcad
Tube bender for D40mm tubes. ...Tested and worked very well. It still retains an option for upgrade to different tubes and bending radiuses.