37mm casing 3d models
205605 3d models found related to 37mm casing.thingiverse
This is a slightly more accurate casing, and it also has a 2 piece round that just has to be glued together. ...This was specifically made to fit in the ammo racks of an M8 greyhound and is almost identical to the real thing.
cults3d
Rough sized model based off of measuring a picture comparing to known 230mm height. ...Fits original projectile tight, had to sand mine a hair.
thingiverse
I simply moved the faces of the wrench outward by 1mm each to increase the inner diameter (jaw-to-jaw) from 28.75mm to 30.75mm across, to fit a 37mm case watch like my Seiko SNK809. Worked perfectly! For those of you opening your case for the...
cults3d
This shell casing fits a 37mm M3 projectile. Roughly took shell dimensions off of a picture. Projectile fits tight, might want to bump up 1% or leave as is. ...230mm tall like original.
thingiverse
This shell casing fits a 37mm M3 projectile. Roughly took shell dimensions off of a picture. Projectile fits tight, might want to bump up 1% or leave as is. 230mm tall like original. ... <iframe width="560" height="315"...
thingiverse
This is a remix for a pixel 3 phone case that incorporates a 37mm phantom 3 standard ND filter.
thingiverse
Opens the caseback for a 37 mm watch with square notches. Tested and works on Seiko 5 SNK809. Print flat with notches on the top side. I used 0.15 mm layer height. Infill doesn't matter too much since it's so thin. ...Mine took 30 minutes at 20%...
thingiverse
It came with a "case", but when you screw the filter onto the phone clip the two together no longer fit in the case! I'm not going to screw/unscrew the filter every time I take it out to use it. That case clearly was made for some other 3...
thingiverse
Payload cups for 3" and 4.5" metal casings. ...Casings must have powder bushing! ...I have not tested these yet but they printed fine!
thingiverse
These are simply 3D models for reference, 3D printed materials may be dangerous for making shell casings. Though for reference they have been printed and the test fit to launcher is good as in they chamber properly and the primer pocket accepts a...
thingiverse
Shotgun style wad for metal 37mm casings. I have not gotten to test this yet! But it printed fine. ...
thingiverse
Customized version of http://www.thingiverse.com/thing:193647 Created with Customizer! ...http://www.thingiverse.com/apps/customizer/run?thing_id=193647 Instructions Using the following options: facets...
thingiverse
Created 37mm standoffs/spacer to use with my MKS Monster8 cooling fan (https://www.thingiverse.com/thing:5428059) and DIN mount (https://www.thingiverse.com/thing:5428083). ... The hole is big enough to fit M3 screws.
thingiverse
37mm projectile for your launcher! ... -Print with the top open and fill with plaster for an inert round -Or print upside down with the bottom open and fill with smoke mix -1:24 RH twist rifled projectile -Optimized for vase mode printing, 45°...
prusaprinters
Created 37mm standoffs/spacer to use with my MKS Monster8 cooling fan (https://www.thingiverse.com/thing:5428059) and DIN mount (https://www.thingiverse.com/thing:5428083). The hole is big enough to fit M3 screws. Print Settings Printer: Tronxy X5SA...