beefcake models
1812424 3d models found related to beefcake models.thingiverse
Customized version of https://www.thingiverse.com/thing:3045130 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=3045130
thingiverse
This is a mount I made to hold our beefcake relay for our Shapeoko. ...I wanted to make some quick and easy to print and mount to keep the wiring clean. Beefcake Relay:https://www.sparkfun.com/products/11042
thingiverse
... Created with Customizer! ...http://www.thingiverse.com/apps/customizer/run?thing_id=162367 Instructions Using the following options: font_size = 15 font = write/orbitron.dxf end_space = 3 label_text = BeefCake letter_spacing = 1
thingiverse
... well. But PLA is cheap, so I applied the "when in doubt make it stout" philosophy of design. I wanted an Rpi case that was thick, relatively heavy duty and easy to assemble, thus was born my "Beefcake" Rpi case for the model Rpi model 3B. ...
thingiverse
Quick mount plate/spacer thing for a SparkFun Beefcake relay. Has a zip-tie strain relief for the output. ... https://www.sparkfun.com/products/13815
thingiverse
I created this cover for the Sparkfun Beefcake Relay Control Kit used in my Lulzbot Taz 6 Octopi installation as instructed by https://core-electronics.com.au/projects/time-lapsing-in-octoprint-properly Mounts to the side of the Taz 6
thingiverse
These models include: HardCore38 & 44, Demon, Mini Drak, Recon, and Souut. Any kit that uses the 28xx sized motors can use this mount. The mount is designed so that the motor sits inside of the mount rather than hang off of the back. There are...
thingiverse
Beefcake was made from a model from https://desktophero3d.com/ using 2 items from the fantasy asset pack and from: https://www.thingiverse.com/thing:3970237 https://www.thingiverse.com/thing:2445147 https://www.thingiverse.com/thing:3098755...
cults3d
wwf brutus the barber beefcake wwf hasbro seie 3
thingiverse
As requested I beefed up the arms and increased to 116mm to accommodate 2.5in props and 1104 motors. 20x20 flight control mount. Also a separate HD Camera mount version to go along with my SQ8 camera mod. ... <iframe width="560" height="315"...
cults3d
BRUTUS THE BARBER BEEFCAKE HASBRO SERIES 1 WWF WWE 1990 RETRO VINTAGE
thingiverse
this one is the BEEFCAKE version.... 1mm thicker and beekcake arms....1mm longer landing gear...enjoy. I bought this kit to rob for the...
thingiverse
NOTE: The printer will need to be lifted up about 0.5" off the supporting surface. This mod will not leave any room for airflow with the stock feet (e.i. print upgraded feet or put some 0.5" blocks under the stock rubber support feet). This fan...