catgenie scrubber 3d models
489 3d models found related to catgenie scrubber.thingiverse
... ... This goes between the rotating bowl and the bowl basin to scrub/loosen any settled debris. The original part is prone to break and I could not find anywhere to purchase it. For more information on the appliance see the manufacturer's site at:
thingiverse
... with a camera and mounted to a CatGenie. ...I have the PiZero serial port attached to the debug port on the CatGenie as well so I can run commands and gather diag data to alert on low soap, various error conditions, and general status of the CatGenie.
thingiverse
Center support post/bearing for CatGenie litterbox. ... Mine was broken when I got it and I could not find the replacement part online, and I didn't want to wait for shipping if I could.
thingiverse
The load-cell "feet" consist of two parts, a "sock", which fits onto the edge of the Catgenie and has a recess to fit the load cell, and a "shoe", which encloses the sock and has a dimple on the bottom for the load cell's protruding button to rest...
thingiverse
I got a used CatGenie for cheap, but it had some broken parts. Rather than pay for all the parts, I modeled some. The impeller was fun to design but a pain to print. I ended up splitting it into two parts and gluing it with UV glue. I also used UV...
grabcad
www.Fajrtabarestan.ir Design Internal Pressure (for Hydrotest) 1200.0 psig Design Internal Temperature 60 °C Type of Hydrotest User Entered Pressure Hydrotest Position ...