cc2531 usb stick 3d models
113012 3d models found related to cc2531 usb stick.thingiverse
This is a small and easy casing for a Zigbee CC2531 USB-Stick as you can buy on eBay, Amazon and many other shops. The pcb slides into the upper part and is fixed with the lower part and two screws. Additionally I made a wall holder for it. It...
thingiverse
### Assumptions * In my CC2531, there are no solders at the bottom of the board except for 2 USB solders at the front and 3 antenna solders at the back, so this design makes these assumptions of the board geometry. ### Parts Requirements * 2x M2x8...
thingiverse
But, because one of the sticks is in my viewing angle if I sit down in the office and the red LED was to bright I decided to modify and add one 0.20mm layer over the logo. This way is a bit dimm and it allso prints easier because it does not have...
thingiverse
Tested with PLA 200°C Both sides should click together and hold by friction without gluing. Some light sanding will be required for the rouded edges. Disclaimer: Not tested for safety of the electronics. This includes but is not limited to:...
cults3d
Tested with PLA 200°C Both sides should click together and hold by friction without gluing. Some light sanding will be required for the rouded edges. Disclaimer: Not tested for safety of the electronics. This includes but is not limited to: thermal,...
thingiverse
Customized version of https://www.thingiverse.com/thing:1896693 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=1896693
thingiverse
SOLID Sonoff Zigbee USB Cover cc2531. ... All parts fit tight.
thingiverse
Summary CC2531 USB housing 1x M3 screw needed. ...See pics glued piece of paper to the inner side of the top plate Printed@ 250 / 80C - printed without supports
thingiverse
Super thin Sonoff Zigbee USB Cover cc2531. Easy to remove one part of the cap for debugging. ... All parts fit tight.
thingiverse
Enclosure for a USB Zigbee dongle (model CC2531) with an antenna. The PCB is secured inside be the dedicated slots and the antenna's nut. ...
thingiverse
This is a model of the cc2531 board with external antenna and female USB connector type A. ... Attached even the source FreeCAD file.
thingiverse
Hi, here is my nice CC2531 zigbee stick case free for modification with your own logo. Edges are round. STL to be used for printing / slicing F3D to be used for editing in fusion360 - Disclaimer: I am not a professional user. Recommendation: ...
thingiverse
I didn't like the cases I found so I made my own. ... It comes with an optional cover for the debug port.
thingiverse
this is a version of the CC2531 Case with external antenna found at https://www.thingiverse.com/thing:3731958 (new version with lower USB plug; without text) with improved assembly. The USB hole in the case is very tight fit, which is good. But this...