cord connector 3d models
73017 3d models found related to cord connector.
prusaprinters
The original blinds cord connector does not keep tightened well because it does not provide any snap mechanism and so can easily fall apart. The model parts snap together and keep the cord well connected. Designed for cords with ball diameter 3 mm...
thingiverse
The String on my bathroom pull switch snapped in 2. It was quicker and easier to design and print this then go and find or buy one from a store or online. Hope it is useful. ... Just put the 2 ends in each side and tie a knot on each end and it will...
thingiverse
Ever managed to break or lose your roller blind cord connectors? I have, many times, so that's why I designed this one using OpenSCAD. Now you can just make your own! For more information about the development of this design please visit:...
prusaprinters
Probably you want to melt the ends to prevent fraying. Poke one end through the "short" side of the connector from the outside, tie a knot as close to the end as possible, and pull the cord back, so the knot nestles nicely in the connector. Repeat...
thingiverse
Poke one end through the "short" side of the connector from the outside, tie a knot as close to the end as possible, and pull the cord back, so the knot nestles nicely in the connector. Repeat for as many cords as you want. Now, to use it, you wrap...
thingiverse
Connects the plastic "balls" of pull cord when the cord has been shortened or damaged. ... Print this item TWICE.
thingiverse
this way you can -make connector thicker in the middle (usefull for snap fit) -adjust thickness of the connector body (important if balls are spaced dense apart) -adjust spacing of the balls -adjust thickness of the cord -adjust snap tolerance...
thingiverse
This is a snap connector for a lanyard or cord I designed this for the Dilbert Tie (http://www.thingiverse.com/thing:217219) so that I could easily put the tie on and take it off. This version of the snap works much better than the original design...
thingiverse
This is a replacement pull-cord joiner. ...The old plastic ones perish in the sunlight, so I knocked this one up instead of buying some from Amazon.
thingiverse
edited original cad files from velleman to replace the small corner brackets. ...like this you don't need to drill any holes or modify the original structure.
thingiverse
This connector is designed for roller blinds consisting of ø4.5mm beads, spaced at ~12.15mm intervals along ø1.6mm cord. The square holes for the beads are 5mm cubes, and cord hole through the centre is 2.5mm wide x 2mm deep. I designed the...
thingiverse
This is used to cover an extension cord connector which I had to replace due to shorting.
pinshape
Summary Ever managed to break or lose your roller blind cord connectors? I have, many times, so that's why I redesigned this one using OpenSCAD. ...Now you can just make your own!
prusaprinters
This holds them snuggly and keeps them clearly visible and organized. The bases can be connected with the cord holder connector. Just glue it on to one side and then glue the other to make a longer unit for holding more cords. They can also be...
thingiverse
Ever managed to break or lose your roller blind cord connectors? I have, many times, so that's why I redesigned this one using OpenSCAD. Now you can just make your own! ...Try create your own in Customizer Open in Customizer Print Settings Rafts: ...