drag v1 3d models
51045 3d models found related to drag v1.
thingiverse
i have Purchased the V1 Engineering Drag Knife to put on on my DIY CNC and one on my modified Openbuilds Acro Laser this is the dimensions of the Drag Knife for making mounts STL and STEP
cults3d
i have Purchased the V1 Engineering Drag Knife to put on on my DIY CNC and one on my modified Openbuilds Acro Laser this is the dimensions of the Drag Knife for making mounts STL and STEP
thingiverse
This drag knife holder is designed to work with my [LEAD CNC generic mounting plate](https://www.thingiverse.com/thing:4849251) and holds on to the [V1 Engineering drag...
thingiverse
I'm not sure if it was my print settings or filament, but the sides of the drag change connector kept snapping off. To resolve the issue I simply beefed up the lower neck/section of the connector and now both sides are nice and stiff. ...I'll post...
pinshape
SummaryI just designed a simple mount for a cable drag chain for my Vulcanus V1 (2016) an thought someone may like to use it as well. The part on the x-carriage (2016 Version!) is glued on to with acetone - the part on the back is mounted with 2 M3...
cults3d
I just designed a simple mount for a cable drag chain for my Vulcanus V1 (2016) an thought someone may like to use it as well. The part on the x-carriage (2016 Version!) is glued on to with acetone - the part on the back is mounted with 2 M3 screws...
thingiverse
I just designed a simple mount for a cable drag chain for my Vulcanus V1 (2016) an thought someone may like to use it as well. The part on the x-carriage (2016 Version!) is glued on to with acetone - the part on the back is mounted with 2 M3 screws...
prusaprinters
I just designed a simple mount for a cable drag chain for my Vulcanus V1 (2016) an thought someone may like to use it as well. The part on the x-carriage (2016 Version!) is glued on to with acetone - the part on the back is mounted with 2 M3 screws...
prusaprinters
Note: You could print two as I did, using one to screw down the lower end of the drag chain, and using the other to attach a zip tie further stabilizing the drag chain. If your existing screws for the "hose-hanger" parts (presumably M5 x 30mm) are...
thingiverse
A mount for the V1 Engineering Drag Knife for use on the Shapeoko 3.
thingiverse
same as the picture of my 3D printer this is drag chain / cable chain for anycubic mega zero v1 and v2 it required no additional screws to install you will need one zip-tie to mount the Hotend connector I used 20 chain link for the X and 20 for the Z...
cults3d
This is a modified version of the model found here: https://cults3d.com/en/3d-model/tool/cnc-3018-knife-holder I have a MySweety 3018 pro CNC and laser engraver which this holder fits perfectly, however the original was too short and with my Z-axis...
prusaprinters
(2) A friend on the V1 Engineering forum remembered once printing drag chain and having a curve in the resulting chain because the printer had some imperfection. So, he recommends having the chain links oriented in all four directions (shown below,...
thingiverse
Customized version of http://www.thingiverse.com/thing:305087 Created with Customizer! ...http://www.thingiverse.com/apps/customizer/run?thing_id=305087 Instructions Using the following options:...