efx racer 3d models
3574 3d models found related to efx racer.thingiverse
EFX RACER - LARGE CANOPY Larger Canopy with more space for large Lipos
thingiverse
Just an attempt of the EFX racer for installing DJI fpv. The rear has to be warmed in order to fit the fuselage. ...Be attached by a nylon screw.
thingiverse
I crash my EFX racer a lot and broke the plastic prop spinner. Rather than make or buy another spinner, i made a cowl extension. There is a good gap for motor cooling, but its not so big as to create heaps of drag. ... There is tape on mine because...
thingiverse
I first printed a Durafly EFX Racer canopy found on thingiverse, but I was disappointed by the result : it didn't fit well. So I designed my own ! Here it is. In order to keep it easy to print (with no supports), there are two parts : the body and...
thingiverse
a friend lost his efx racer battery hatch during a flight so asked me to make a new one with my 3d printer because hobbyking don't have in stock any more. unfortunately i don't take any picture of the finish job but it fit very well on the plane, i...
thingiverse
A small pod made to hold a Sony Mini 600tvl Super HAD CCD camera on the front of the Durafly EFX Racer model aircraft. The camera is held in place by clamping force and can be tilted. ...On rough landings the camera will tilt or jump loose.
thingiverse
A spinner replacement for the Durafly EFX-Racer. Requires self tapping 3mm screws. *********************************************************************************************************** Update 16.07.2021: Added a updated version, made...
thingiverse
COWL FOR EFX RACER For use with a turnigy / dys 3536 motor. with collet style prop adaptor. ... I've used a folding 10x5 prop and a 1000kv motor
thingiverse
A Durafly EFX Racer canopy designed for holding an Insta360 One camera ! ... 5% infill is enough Here is a videos that shows the result : https://youtu.be/L0rU-AwaCOo
thingiverse
PIR Sensor Simple case / Mounting option for the EFX-TEK Parallax PIR sensor including an optional range/limit shield and mounting pins. The design uses the included mounting pins to secure the board and range cone(optional) to the mounting base. ...
thingiverse
My Precor EFX 427 elliptical has always had a banging noise from the arm joint and these small 3D printed discs solve the issue. Service did not fix it, as it is a design flaw. They over-engineered this and refuse to use plastic parts to soften...
thingiverse
This thing was made with Tinkercad. ...Edit it online https://www.tinkercad.com/things/2UigTQLUhvS
thingiverse
Customized version of http://www.thingiverse.com/thing:53235 Created with Customizer! ...http://www.thingiverse.com/apps/customizer/run?thing_id=53235 Instructions Using the following options:...