et tube rack 3d models
121630 3d models found related to et tube rack.thingiverse
Tube rack holder. can be used for 15ml tubes or conical tubes. Racks from companies run from $50-%100, this rack can be printed for ~$3. ... Visit our website at: www.downloadablelabs.com
thingiverse
Tube rack for noble gas tubes. Print with letter sides down 20% infill and with/without support. ...
thingiverse
This is a tube rack with a .5in holes and it makes a good pencil, tube, or tool holder for your work area. ...i made this for a science teacher for my school.
thingiverse
This plastic Z-shaped rack is designed for holding 2 50ml tubes, 4 15 ml tubes and 5 eppies. It can be personalized by adding a text in the middle. The Z-shaped is sturdy and limits required material for printing. Can be printed without supports but...
thingiverse
It is a test tube rack, to present them with a sort of carousel. ...More pics here :http://www.flickr.com/photos/watsdesign/sets/72157625557594408/ Instructions Print : 2 discs, 2 spacers, 1 base And...
prusaprinters
can be used as a rack on your lab bench, printed with ASA for chemical resistance
myminifactory
... It was designed for tubes that are outer Ø=52mm, so that is the default diameter. The zip ties used at the original scale are 4,8mm wide and need to be minimum 250mm long to assemble this comfortably but shorter could work. ...Ours was 300mm.
cults3d
... diameters. It was designed for tubes that are Ø=52mm, so that is the default diameter. The zip ties used at the original scale are 4,8mm wide and need to be minimum 250mm long to assemble this comfortably but shorter could work. ...Ours was 300mm.
thingiverse
Here is a simple snap in rack that works with my industrial paper towel tube caps.