fanatec formula v2 3d models
108772 3d models found related to fanatec formula v2.
prusaprinters
I recently upgraded to Fanatec QR2 and wanted a way to display my spare wheel. But I didn't want the mounting system to go near the electrical pins or rub on the connection mechanism.This design just allows the wheel to slot into the stand without...
thingiverse
Button Pod Brackets for Fanatec Clubsport wheelbase For use with NASCAR Podium Wheel, Clubsport Classic Wheel, Momo Mod 07, & similar 350mm 3 spoke deep dish racing wheels. Great to improve accessiblitly to all of the buttons available in the...
thingiverse
This is a table mount for the [Fanatec CSL DD wheel](https://fanatec.com/us-en/racing-wheels-wheel-bases/wheel-bases/csl-dd). It is an alternative to there table mount that is more ridged and that keeps the wheel centered over the table rather than...
thingiverse
I wanted to use an OEM BMW shift knob with my Fanatec Shifter, but I couldn't find an adapter to go from the M12 thread on the shifter to the BMW slip rod. I took some measurements and created this, which screws on to the Fanatec shift lever and then...
cults3d
Formula One, commonly abbreviated to F1, is a motor sport discipline considered to be the premier class of the sport. ... Print Scale 5/1
thingiverse
A button box for the original fanatec CSR wheel. Since I replaced the original wheel with a sparco wheel, i needed a place to relocate the buttons that were on the wheel. So designed this to drop the original PCB board that was on the original...
thingiverse
There are lots of neat attachments for the side of your Fanatec DD1/DD2 Base (button boxes, Streamdeck connections, etc), but most of them mount perfectly vertically (well - aligned with the base). For me, thats almost always the wrong handle,...
thingiverse
Support for using my Phone Samsung S6 Edge as a dash on a Fanatec CSL Elite Wheel. The support fixes the case i use to protect my phone with 4 points. Bigger hole for the nuts to fix it on the wheel base are slighlty tight to make the nuts stay...
thingiverse
You can then adjust the "calibration_factor" variable at the top of the Arduino code until the Fanatec brake and the Arduino brake are very similar in range when the brake pedal is fully depressed and voilà, virtually no getting used to the new brake...