ikea cable box 3d models

I grabbed one of Ikea's little nylon box called "Glis" with a nice lid and converted it to a cable box. I used two piece of printed side supports for the bar in the middle. I got a wooden bar since it is easier to make(and quicker too..) but you can...

practical box to organize the cables of the led lights.I made a hole to pass the cables coming from the switch placed in the upper part of the ikea lack,i leave you the link of the switch holder...

https://www.ikea.com/sk/sk/catalog/products/90289836/ https://www.ikea.com/sk/sk/catalog/products/10412029/

infill 10% layer high 0.20

infill 10% layer high 0.20

Box IKEA

Standard Ikea Box

Ikea KRYDDA cable clip

Cable Duct Ivar Ikea

IKEA FURNITURE CABLE CLIP CLIP SUJETA CABLE MUEBLE IKEA

Edit it online https://www.tinkercad.com/things/7dIuyrrM0Q0 My daughter wanted a tiny box during out last IKEA visit. Being too cheap to spend 3.99, I opted to spend a day designing and printing a working version. ...Good thing I don't have to pay...

A small cable holder for the IKEA Skadis pegboard.

IKEA VITTSJÖ - Cable Clip, snap-on, perfect fit

ikea

Cable Box

You can use this Cable clip for Cable management on the IKEA Lack table

A simple cable holder for ikea forniture. ... PLEASE PRINTE WITH ALL SUPPORTS ENABLED! Un soporte de cables simple para los muebles de ikea.

Cable clip for cable management. ...Is sized to fit on the side of an IKEA LACK table top or leg.

Small clip allowing a cable to travel along the edge of the IKEA Billy bookcase.

Simple cable holder for IKEA Linnmon tables. ... Sits very tight and doesn't move around.

A replacement for original IKEA cable port, missed in my office.

A 71 mm cylinder desk cable insert. ...Used to fit an Ikea Desk.

Cable Box for Cable Spule

IKEA LINNMON PHONE CHARGE CABLE HOLDER You may need support. Locking mechanism is quite tight. ...Works well.

Perfect for cable management on the Ikea Skadis. Succesfully printed on ender 3 v2 without support with white PLA. ...

Perfect for cable management on the Ikea Skadis. ...Succesfully printed on ender 3 v2 without support with white PLA.

A simple cable holder designed for Ikea SVALNÄS. No screws nor glue needed. ... Designed to be printed without any support

Made this cable holder to "plug" at my IKEA skids and maintain my apple watch charger in "place".

A small cable holder for ikea brimnes bed. ...Holds 3 cables which can be pulled out and put back in without

A smaller version of the standard Ikea Hemma cable cover - choose between three different cable outlets (none, one, two) for connecting lamps. ...