jst header 3d models

This project is a JST header adapter for Microduino Sensor Hub v1.0. It make easier to connect JST into a Microduino's Sensor Hub. ...

SMT / SMD headers which I drew for an old CCD sensor board assembly

header 3 pin to 11 pinB3B; B4B;B5B;B6B,B7B.B8B.B9B.B10B;B11B

Model - Connector JST XH 2.54mm Header 3 pin. For modelling purposes not for printing! p.s. i'm not found original information about 2.54mm version... datasheet exits only for 2.5mm.. ...but china modules have 2,54mm 8(

Print this battery header as a replacement when converting your TinyWhoop / Inductrix 1S 200maH battery to JST-PH 2.0 (aka the PowerWhoop connector). The JST-PH 2.0 connector should provide better electrical contact and power delivery and thus tries...

JST 6pin XH2,54 right angle pin header connector terminalStep and Iges files

http://www.jst-mfg.com/product/pdf/eng/eXH.pdf

http://www.jst-mfg.com/product/pdf/eng/eXH.pdf

http://www.jst-mfg.com/product/pdf/eng/eXH.pdf

Low level model of JST connector commonly fount on 5S LiPo batterys

Couldn't find any male connectors readily available, especially non-board mount ones without pigtails, so I decided to make some housings for 2.5mm pitch header pin strips, which work perfectly. ... Enjoy!

Header

HEADER

A USB3 Motherboard Header

The basic header I made and rendered in visualize with the route 66 backplate.

Headers are one of the easiest bolt-on modification. ...It helps in eliminating the manifold back-pressure.

Header 1pin, 2pin, 3pin, 4pin, 5pin, 6pin, 7pin, 8pin, 9pin, 10pin 11pin, 12pin, 13pin,14pin, 15pin, 16pin, 17pin, 18pin, 19pin, 20pin.

(Yet another) LED strip mount, this time with 3-pin JST-XH headers for daisy-chaining neopixel strips (5V / Data / GND). I have mounted this under the (ouch-pointy) corners of the bed using two 3mm wood screws for night-time orientation, in case...

JST S2B

Splitter for four prong jst connectors

Test File for JST SM connector Punchout/Panel Mount

I simple shroud for JST connectors, which makes it easier to disconnect.

Fed up with silly harnesses and power distribution board? ...Make a JST power board! I'll also make a 5v backplate. I'm using 22AWG solid core wire for the harness and standard JST pins.

This is a JST secured Socket for secured connection of 2S Lipos with JST Plug to receiver for example. This is designed to prevent powerloss and to prevent polarity reverse. ...

Header 6 pin macho JST 1.5mm PITCH

Header 4 pin macho JST 1.5mm PITCH

Header 8 pin macho JST 1.5mm PITCH

Header 2 pin macho JST 1.5mm PITCH

Header 3 pin macho JST 1.5mm PITCH

Header 10 pin macho JST 1.5mm PITCH