scotts steering dampener 3d models
14505 3d models found related to scotts steering dampener.grabcad
this is the steering dampener mount for a scotts steering dampener that i made for my 2002 cr250. ... it mounted up perfect.
grabcad
Tool to properly pull off the link arm on a Scotts Steering Damper for dirt bikes or motorcycles. I made this from Steel .428 thick, but could be any thickness down to 1/4". This and the bullet tool for installing the vane thru the seal so the seal...
grabcad
Tool for re-installing the vane on a Scotts steering damper. This prevents the sharp edge on the shaft from sheering the seal edge when installing the Vane. ...I 3d printed this but it need to be sized in a lathe, the printer struggled to hold the thin...
thingiverse
Steering wheel dampener for volvo 340/360 not made for 3d printing
thingiverse
Bought a bike that came with a Scotts steering damper unfortunately is was missing the original knob and cap. ...I made some replacements and they have been working well for a while now.
grabcad
Dummy made for modeling around. NOT A PERFECT MODEL. ...There are some variations on the radies, none of the bolts and there is no arm.The width is based on my Öhlins, and there may be some variations.The number on the backside of mine is: SD4250...
thingiverse
Get cables out of the way and not rubbing on the stabilizer body. Included is the guide itself and a spacer needed to mount properly. Spacer should be metal and you need 2 of them. Hardware is not included, but you will need 2 bolts that are ~15mm...
thingiverse
It's a holder to hold toilet paper rolls, it works perfectly with Scotts brand, not sure if other brands will though.
thingiverse
Designed this replacement knob for my scotts broadcast spreader handle to replace a missing knob. Using a 10mm nut as an insert that threaded onto the existing bolt this knob is a perfect replacement for a broken or lost handle knob. To print: ...
thingiverse
I got a scotts elite spreader and didn't like that the paddles were just pins, So I made this one. There are a few different versions: half - is if you want to use the existing cotter pin to attach it. (single sided paddle) full - would require...