makerbase mks tft35 3d models

I don't know how to handle this on other boards, especially the LM's stock MKS board using Teacup (earlier versions: Smoothie) firmware. If someone can figure this out, I would be happy to add the information.</p><p>For the Duet, just open the...

MKS 1.4, GEN L, Trigorilla or Fysetc F6. Your boards needs to have an AUX-1 port with direct access to the onboard serial port.</p> <p>BOM:</p> <p>Arduino Nano 3.0</p> <p>Joystick module</p> <p>(e.g. <a...

They are called 8-pin JTAG IDC connector. I made these Cable Clip for a long time for a 3D printer, but I printed a lot of them, so they came in handy. And these clamps were designed at the last moment of the final assembly. Standalone controller...

"Mirror Body" refers to the aluminum structure between the mirror and the camera. Parts needed: Rearview mirror from a 2013-2019 Ford Explorer, Ford Taurus, Lincoln MKS, or Lincoln MKT. I've had good luck searching eBay for '2016 mkt rearview' and...

I had an older MKS board and display kicking around but really never like Marlin that well and never got very good prints from it. Seeing a review on the Lerdge K I ordered the entire kit from their website for ~117US shipped. It arrived 2 weeks...

Don't yet know how :P For now, just carefully measure, mark with a sharp knife and break away with pliers an amount of plastic of the "flag" so the Y-axis stops just short of the hard limit. Update feb 1st, 2021 I am abandoning the idea of fitting...

While it is designed specifically for the Prusa i3 MKS series (working with the printer's filament runout sensor cable), it only actually requires a 5-volt circuit which is likely available on most printers. This board splits the input directly into...

Other motherboards that can run RRF include many 32 bit LPC or STM32 motherboards including many of the 32 bit boards labeled MKS, SKR, and Fly, but not all. The ability to drive nine steppers is also a requirement. Eight drivers can be used if...