midgar model

I made a small stand to balance the Midgar 3D model made by Jukka Seppänen (https://www.myminifactory.com/object/3d-print-midgar-101209) The stand should fit perfectly to the original size of the Midgar model. But in case it doesnt.. ...the ratio...

Shortly after he’d lost his eye Wotan noticed that he started to see the world in a different light. Any technical design looked like a flat blueprint. All flaws became glaringly obvious and Wotan immediately sought to correct them by adding new...

... expose the LED before putting it in the bottom. . NOTE: Make sure you set layer heights to 0.1mm when printing this, I can't stress this enough, the model was designed around a 1/10th mm printing scale not 0.06 or 0.15, set a custom layer height.

Model

model

Model

model

model

model

model

model

model

Model

model

model

MODEL

Model

MODEL

model

model

model

model

MOdel

model

model

MODEL

Model

Model

model