minipro dyno 3d models

All the hardware needed, except for the wood screws, comes with the Prusa MMU2, which I'm repurposing to replace the subpar 'dyno' style spool holders it includes, which are flimsy, can't be screwed down, and most importantly, cannot be...

You can see some dyno results for the HS4 MG case here: http://mgaguru.com/mgtech/power/pp104b.htm Furthermore, many user's have reported quieter carburetor noise. This, to me, is indicative of reduced turbulence at the carburetor inlet and therefore...

... my case, the engine check light came on and the car ran rough after installation. It's possible that a dyno tune might resolve the issue, but it's essential to have enough time and spare parts available in case you need to reverse the modification.

My electronics are based on an Arduino MiniPro and a 4-channel FET switch board (see eBay link). I also needed a rectifier/filter board to convert AC power to raw DC, as well as two small regulators – one for the LEDs (12v) and another for the...

Also, it may be increasing the performance slightly, but my butt dyno isn't calibrated well enough to say. The stock intake ducting definitely muffles the intake, as the engine sounds much more snarly now, which is very cool in my book. To finish...

You can see some dyno results for the HS4 MG case here: http://mgaguru.com/mgtech/power/pp104b.htm Furthermore, many user's have reported quieter carburetor noise. This, to me, is indicative of reduced turbulence at the carburetor inlet and...