mold a vagina 3d models

Vagina in a high-quality 3d model. ...Use it for mold, jewel, joke or whatever you want!

Vagina scale model. ...Two files, one general and one reduced.

3D printable vagina model for making art, pranks or whatever you want! ... Attention, the back is not flat.

... its own built-in stand! Simply print the casting mold and pour the silicone inside. Also included is a Dildo that you can print with flexible plastic ( BFlex, nylon..) You can also use other models: https://cults3d.com/en/users/DiaSky/creations

Naughty keyring.

Silicone Vagina (for silicone molding) Mold to make a silicone vagina for male masturbation, large size for large penises, allows greater comfort thanks to its size and its tips that stimulate the glans and the entire shaft of the penis. #CASTING...

vagina keychain

keychain vagina

Vagina Keychain

Mold part A

mold a plate

Flanges to hold the vagina support in order to install it on a sliding slide.

a Mold of 2 products

Vagina model for educational use.

I have drawn a basic plastic injection molding in NX

60x60x15

Punch of a mold's electric box drawed during summer holidays to improve on SolidWork.

A dodecahedron concrete mold, just two peaces and all you need it some rubber-bands to keep them together when molding. I used some silicon on the inside just to that the concrete should't stick to the mold, but I'm not sure if that's necessary if...

This is a basic mold design on NX. ...First of all I must say, this is very unprofessional design.

Simply a cupcake mold Instructions Simply fit pieces together and inject material through the back. ...Any questions or suggestions welcome.

This is a mold to put curves into a skate/longboard. ...This will be CNCed and is made out of two 1" thick 12"x 48" boards of mdf.

... rig. ...I made 2 versions. One 3 wire and one 5 wire. I used a Do-It mold for the jig head. Using that as my base I created a collar that can be used to hold the wires together while the jig sets. ... I used homedepo marker flags for the wire.

There are two sinkers that can be made using this mold: a 4-sided sinker and an 8-sided sinker. If you cast them in lead, then they ought to weigh about 4 oz and 6 oz respectively. There are holes in the molds where you can slip in wires before...

This is a burger mold. You put some minced meat with spices and some plastic wrap to protect it. It can hold about 150 g of minced meat, but you don't have to fully fill it. You don't have to freeze it to make a perfect hamburger, just squeeze it...

Masturbation Vagina Support : No Infil : %20 Speed : 25/ms 0.3

I've seen a lot of vaginas on this site, but none were modelled too well. This is my first attempt at something a little more aesthetically pleasing. I'll next be trying to make something a little more artistic but much on the same theme. It will be...

it is a bottle cap

This is a requested object.

Inspired by Wuerfel's fantastic [MoldMold system](https://www.thingiverse.com/thing:3828391) to produce something similar that would produce a free standing mold. I have created this to produce molds that are less versatile (they're cubes!) but...

This is a simple medallion.