printable quarter 3d models
112945 3d models found related to printable quarter.thingiverse
When I tried printing the quarter model this one is derived from, none of the surface geometry was printed, even when sliced at 0.1mm resolution. This model trades off absolute accuracy in favor of printability by slightly increasing the feature...
cgtrader
3D printable knob with 0.25-20 UNC 2B thread. It is recommended after printing to chase the hole with a 0.25-20 UNC 2B tap to remove any excess material. Knob has an overall lenght of 0.75 inches. Note: STL was saved in inches, and may require...
thingiverse
Customized version of http://www.thingiverse.com/thing:193941 Created with Customizer! ...http://www.thingiverse.com/apps/customizer/run?thing_id=193941 Instructions Using the following options:...
thingiverse
This object was made in Tinkercad. ...Edit it online https://www.tinkercad.com/things/dsQa1rYvnjE
thingiverse
This object was made in Tinkercad. ...Edit it online https://www.tinkercad.com/things/dsQa1rYvnjE
thingiverse
Customized version of http://www.thingiverse.com/thing:193941 Created with Customizer! ...http://www.thingiverse.com/apps/customizer/run?thing_id=193941 Instructions Using the following options:...
thingiverse
Quarter holder with marks for each dollar of quarters. Very easy print. ... Enjoy, Xavier
thingiverse
US Quarter holder with screw on lid. Holds $10 in Quarters. ...There is also a viewing slot on the side.
thingiverse
Used in place of a quarter in a shopping cart. ...Will work on Canadian and American quarter coin carts.
thingiverse
Just a little container for all of my loose quarters. ...The lid should snugly fit on top of the container to prevent quarters from going anywhere. ...This is for American quarters, but feel free to remix it for other coins!
thingiverse
Slot for quarter is 1 in. ...diameter quarters are 0.955 in. diameter, tight fit. ...I'd love to see your makes!
prusaprinters
... 40 quarters. ...It was designed for Canadian quarters but should work for American quarters as well. I printed it in PETG so it had a bit more flexibility and strength. ...Printed at 0.2mm layer height, with perimeters increased until it was solid.</p>
thingiverse
This boat was designed under the IOR rule and fell into the quarter ton calass
thingiverse
When I went out for more quarters to do my laundry today, I realized that the paper rolls that the quarters came in aren't a good form to dispense the coins. I only ever use quarters for anything, so I only needed the one size of opening. This...
thingiverse
This is just a Fake Quarter, just to test your gum machines if they are anti-fake quarter. USE ON OTHER MACHINES AT YOUR OWN RISK. ...I AM NOT RESPONSIBLE.