printrbot power supply 3d models
126306 3d models found related to printrbot power supply.thingiverse
Instructions *Do this at your own risk 1) unplug power supply 2) remove 4 screws on the grey side of power supply 3) tuck wires into power supply - keep the Printrbot's power supply wire free (i also kept one IDE power cable free for future fans) 4)...
thingiverse
This is a bracket that allows mounting of a Mean Well RPS-300-12-C power supply in the base of the Matrix Precision EX-105 upgrade for the Printrbot Play.
thingiverse
Permet d'assemblé deux alimentation PC fournie avec les Kit Printrbot, pour crée une alimentation DC 12V 12Amps . ... ...
thingiverse
This thing contains covers for making a replacement power supply for a Printrbot Simple (and possibly other) printers. Instructions The hardware for this thing requires: ============= 12V 20A LED PSU switch of appropriate voltage one dead or dying...
thingiverse
After I upgraded my Printrbot Metal Plus to a Corsair CX430 ATX power supply I had been wanting to find a solution to mounting the power supply, I was trying to save space and any attachment to the sides was out of the question, I decided I wanted to...
thingiverse
The original power supply cannot supply enough current for connecting a heated bed and Printrbot recommends using an ATX power supply instead. XBox 360's power supply is a great alternative - powerful, quiet, and better-looking than an ATX one. The...
thingiverse
Two part case to hold an ATX power supply for a PrintrBot Simple Metal with Heated Bed. This can be printed by the PrintrBot Simple Metal - each piece just barely fits in the 150x150x150 build envelope. I had to modify my ATX power supply case so...
thingiverse
Remix of orangefurball's legs, slightly extended and modified to mount an Azteeg x1 as well as a 215x115x50 power supply ( like this: http://store.quintessentialuniversalbuildingdevice.com/product.php?id_product=111 ).
thingiverse
Together with Big Foot http://www.thingiverse.com/thing:62614 the power supply can be mounted under the printrbot. Instructions In each of the rear Big Foot is a 3 mm hole. make a 3 mm thread in each...
thingiverse
This is a base for an ATX power supply for a printrbot simple metal with heated bed. It cleans up the wiring by keeping the ATX wires internal to a case. My first version of this (Thing #512601) used a smaller power supply and was build-able in two...