retropie n64 controller 3d models
154628 3d models found related to retropie n64 controller.
thingiverse
Wire the fan through its hole and connect it to the labeled pins: 5V (Power), GND (Ground), and GPIO 14 (allows you to control fan speeds using software)...
thingiverse
This project is for a Raspberry Pi 4b+ housed within a C64C case, inspired by https://www.thingiverse.com/thing:4413053. I'd like to extend my gratitude to PitMan from Berlin for providing the case. Here's an overview of the parts used in this...
thingiverse
Another Arcade Bartop! This time one in Vertical mode... My previous Bartop: https://www.thingiverse.com/thing:4441100 All materials are almost the same. The LCD that i use this time: ...
thingiverse
I revamped the PiStation model to work seamlessly with the hardware I had on hand, and since this was a gift for a friend, I also incorporated a relief of his logo right in the center of the faceplate. You can personalize the faceplate however you...
thingiverse
I wanted to build on the great work done by Mediaman2000, but I needed a LAN socket. So, I decided to create my own variation using some parts from his design and adding some of my own. ... Here are the components I used: HDMI corner: This is where the...
cults3d
Another Arcade Bartop! This time one in Vertical mode... My previous Bartop: https://www.thingiverse.com/thing:4441100 All materials are almost the same. The LCD that i use this time: ...
thingiverse
I'm working on a Raspberry Pi 4b+ housed in a Commodore 64 case. I've taken measurements from Von_Bednar's great work, specifically Thing:3691730, but I needed additional parts and USB-C for powering the Pi. My Part3 was inspired by smh's design,...
thingiverse
This is an additional feature for the stackable Raspberry Pi case. ...It features an 8-bit design of the RPi logo, accompanied by ventilation holes on both the top and bottom sections, replacing the original parts accordingly.