simplify3d fff abs anet a8
100516 3d models found related to simplify3d fff abs anet a8.
thingiverse
Simplify3D G-Code File Format FFF This is an open format that specifies how to convert a 3D model into a sequence of G-code commands for printing. ...It's widely used with RepRap and other FFF/FDM printers, and supports various print settings like...
thingiverse
... surface. This calibration is for a Replicator 2 with Sailfish firmware 7.4, and various materials were printed at specific temperatures: ABS at 235°C, PLA at 215°C, and Nylon at 235°C. ...The filament diameter during calibration measured 1.75mm.
thingiverse
I used 15% zigzag supports with support interface roof enabled but not interface floor.\r\n\r\nI printed with Esun ABS+ but you can probably use whatever for it. Takes just over an hour at 0.2mm layers / 80mms using 0.4mm nozzle.\r\n\r\n***Required...
thingiverse
Simplification3D failed to slice the original model accurately, so I reprocessed it through Meshmixer and that seemed to resolve the issue. I noticed the narrow gaps at the top of each loop section were intended to be thin walls, but they turned out...
thingiverse
This is a carriage for axis X for anet A8 with BMG Fabricated in ABS
thingiverse
... is 7.7 Millimeters. Contact Me for Any Improvements :) Only Suitable for 1.75mm Filament! Print Settings Printer: ANET A8 - Prusa i3 Rafts: Doesn't Matter Supports: No Resolution: 0.2mm Layer Height Is Enough Infill: 20% Is Usual for This Project
thingiverse
It still has 310x310 build volume, still uses the stock Anet A8 Y carriage so accepts any bed that will fit on that, and has extension parts for a 310x310 bed to be mounted on the original Y carriage. E3D-V6 carriage. For the full 310x310 build...