sonicare hx6100 3d models
432 3d models found related to sonicare hx6100.thingiverse
Remix of [Sonicare HX6100 wall mount](https://www.thingiverse.com/thing:1118084) that can be used with 1 1/8" suction cups to mount to a mirror. ...
thingiverse
Sonicare HX6100 charger wall mount. This charger is used for lots on different sonicare model brushes. its a snug fit some very minor sanding or careful flexing may be needed to get it in. I used ABS which tends to shrink, PLA may make for a easier...
thingiverse
This is a **wall mount for Philips Sonicare HX6100 chargers**. It's intended to be mounted to a wall or tiles using double-sided tape such as 3M VHB and resembles a Feller light switch to blend in nicely. Note that this is the EU charger version...
thingiverse
Customized version of https://www.thingiverse.com/thing:2430796 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=2430796
prusaprinters
Holder for Sonicare 2 Series bush and stand. ...I used minimal supports under the little wing sections.</p>
thingiverse
Just a holder for two Sonicare toothbrushes. Once with space for the charger. ... My first Thing ;) Pls comment if there is something wrong or what could go better ;)
thingiverse
Set of wallholders for Sonicare brushes and charger. Holders are customized for genders and smaller gender marks for kids. It is easy recognize for kids. Holders can be attached (glued) together with holes and fragment of filament. For attach to...
thingiverse
My Father complained that the sonicare falls over way too easy even when it is on the charger. Here is my solution to the problem. It's very stable and fits the charger too. You can pretty much throw the toothbrush in and it'll charge and wo'nt...
prusaprinters
I am unable to upload better. Print instructionsCategory: Bathroom Summary Set of wallholders for Sonicare brushes and charger. Holders are customized for genders and smaller gender marks for kids. It is easy recognize for kids.<br/> Holders can be...
prusaprinters
Printed (with PLA on Geeetech A20M) and tested on Sonicare 4300 model. Sliced with Cura using these settings:Layer height: 0.15mmTop/Bottom Layer: 0.9mmWall thickness: 0.9mmWall count: 2Infill: Grid,25%, 0.15mm thicknessIroning: Whole...
thingiverse
Simple stand to hold two Sonicare toothbrush heads upright.
thingiverse
simple brushhead holder for philips sonicare. ...Holds 3 brushes.
thingiverse
A holder fixture for two philips sonicare brushes. ...Nothing fancy
thingiverse
Double stand for the charging stations of the Philips Sonicare toothbrush. ...
thingiverse
Holder for Phillips Sonicare heads that keeps them dry and separated from each other