tension puller 3d models
19039 3d models found related to tension puller.cults3d
I noticed that several people had a problem with the puller delaminating because it was printed vertically and 3D printed pieces that are used under tension are inherently weak in this direction. I made a slight modification so it could be printed...
thingiverse
I noticed that several people had a problem with the puller delaminating because it was printed vertically and 3D printed pieces that are used under tension are inherently weak in this direction. I made a slight modification so it could be printed...
thingiverse
... for this belt tensioner. ...Print it horizontally with support for more strength. The GoPro Mount is designed to fit into puller nut. ... The original project: https://www.thingiverse.com/thing:2986144 https://www.thingiverse.com/thing:2013603
thingiverse
le tensionneur n'est pas assez grand pour l'axe des X sur le fichier original. ...Je l'ai donc rallongé de 10mm
thingiverse
Original Source: https://www.thingiverse.com/thing:3213207 I've used above belt tension system on my printer(Anet a8), which has A8 mainboard V1.7. Two things have been modified. - Puller became slimmer to fit well with a supporter frame. -...
thingiverse
Update 2019/02/17: See this thing instead https://www.thingiverse.com/thing:3433346 Update 2018/01/14 : bracket_offset_rev_v2.stl, trimmed to reduce/eliminate rubbing with belt The bushing and bearings won't fit in the original puller, puller gap...
thingiverse
Remixed to remove the hex nut recesses as these seemed an unnecessary weak area and my original failed across the bolt axis. Also added a couple of thin shim washers to narrow the gap to suit the bearings and spacer tube length. ... Printed mine in...
thingiverse
Modified the puller to be stronger because i broke it two times. you can use the original screw to go through the bearings. no need for Bearing sleeves. ... Also i use the knob from Y-Tensioner
thingiverse
this is a tail boom puller for the XL Power Specter 700 RC Helicopter to help you set the tail belt tension correctly and easily. ... Bolts and Nuts are all M3
thingiverse
this is a tail boom puller for the XL Power 520 550 RC Helicopter to help you set the tail belt tension correctly and easily. ... Bolts and Nuts are all M3
thingiverse
This is an extended "puller" for the flying helicopter toy http://www.thingiverse.com/thing:1885007/ I printed the helicopter at 50% size and the puller was a bit short. ... This puller is sized for 50% of the original.