thing universe 3d models
1430355 3d models found related to thing universe.thingiverse
This thing was made with Tinkercad. ...Edit it online https://www.tinkercad.com/things/9QWb1Do5i4o
thingiverse
Please visit https://www.thingiverse.com/thing:4292905 for all related parts for this Filter Cap.
thingiverse
The first alternative uses countersunk bolts and was created by Tunell: http://www.thingiverse.com/thing:11775/ The second is the derivative of this one by M_G that adds a layer of plastic under bolt: http://www.thingiverse.com/thing:14098...
thingiverse
A slight modification to Gossamer's thing that adds sections with a narrow diameter at the bottom of the bolt head holes. This makes it less easy to install (you have to completely remove the bolts) but I think this will make it less likely to slip...
thingiverse
This is a tube for http://www.thingiverse.com/thing:581788 So you don't have to buy aluminium tubes ;) On the inside there are 2 stops to prevent the 608 bearings from slipping too deep into the tube. ... Works fine for me.
thingiverse
Thanks to the inclined surface the attached things are centered and preloaded. This alleviates the rattling and makes it sturdy in vibrations. For now there are two top plates: for camera and general mount. Let me know if you like me to add...
thingiverse
... the job quite nicely. ... Replaces the M3 set screws that normally hold the J-Head host end into the uniX-Wade Universal extruder. http://www.thingiverse.com/thing:25416 Instructions Snap off the anchor pads, and sand the edges clean for a smooth fit.
thingiverse
I was needing a mount for my radial fan recycled from an old HP computer. ...3mm holes.
prusaprinters
<p>Changes to original:</p> <ul> <li>Outer walls width 1.6 mm for 0.4 mm nozzle print</li> <li>Inner wall width 0.8 mm for 0.4 mm nozzle print</li> <li>Solid outer walls</li> <li><p>Shortened ~5 mm to fit better into Eldricht Horror box Wall width is...
myminifactory
I designed this wall hook for my backpacks and for a motorcycle helmet. I like the steel structure design so I tried to give it that look. Ptrinted on PLA with 15% infill. ...No supports and no raft required (at least for me it wasn't required)
thingiverse
Customized version of https://www.thingiverse.com/thing:2850939 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=2850939