turbobee 111r 3d models

Canopy turbobee 160 FPV for personal use only

... electronics are junk and will smoke on you. You have been warned. Simple one screw angled wall mount to store and display the Iflight TurboBee 136RS quad. Screw hole is 5mm for the shaft and 9mm for the head. ...Prints flat with no supports needed.

Remix from Insta360 Go mount for iflight DC3 to TurboBee 77R

Custom pod for the iFlight Turbobee 120RS I call the Dragonfly. The default pod exposed the antenna to crashes and didn't have much of a fin for turtle mode. ... Original pod 3g, this one is 10g

I designed this propellers guard structure for my iFlight Turbobee 99r The aim was to replace the original prop guards that have endured a lot but in the end they succumbed to the repetited collisions. ... So while waiting for the replacement arriving...

I designed this propellers guard structure for my iFlight Turbobee 99r The aim was to replace the original prop guards that have endured a lot but in the end they succumbed to the repetited collisions. ...So while waiting for the replacement arriving...

3/8/2021 Corrected file issue with TurboBee Canopy SC V1.1 11/2/2021 Recently rebuilt my TurboBee on a stronger custom frame. I thought the TPU parts could use an update as well. ... Added a fixed 40 degree cam canopy, thicker battery strap guide for...

This is a part based on the part that includes the iflight turbobee 136rs kit to put an immortat t antenna on the quad but the original part cannot be used correctly with the screws included in the kit because they are too short and the nuts are not...

material:TPU This parts is mounting Caddx Baby Turtle on iFlight TurboBee 136RS.

This is a simple foot for the amazing iFlight TuboBee 77R. You will need to replace the motors bolts with a few larger ones. ... Print it on TPU with a low speed to be perfect.

I didn't test the PETG Propguard on my Turbobee120R but the PLA Propguard on my Turbobee77R works fine :) Edit: Added Turbobee 136RS If you need something please let me know. ... Happy Flying :D

This is a replacement upgrade top plate for the Turbobee 136rs and 120rs which incorporates ports for a Micro AXII shorty and XM+ receiver. This top plate is also lighter than the stock TPU canopy. Note: If you're using this on the 120rs frame...

Material:TPU Buzzer size:D=9mm

This is a mounting parts Runcam Split 3 Nano on iFlight TurboBee 136RS. Matrial : TPU Added ver2 model data.(runcamsplit3nano-adapter.stl). ... circuit board upper surface is covered with frame.

Insta360 go mount for original iFlight 120RS.