ultragauge mount 3d models
348096 3d models found related to ultragauge mount.thingiverse
Don't hate on me I'm not a designer just a broke college kid. ...However, feel free to enjoy my gauge mount. ...I printed with supports everywhere and ASA filament And it's holding strong in West Texas heat.
thingiverse
I took the holes out, increased width of the middle section and added a flat-base mounting option that works well for my Jeep. I printed it in PLA, with the curved bits facing up (if the gauge were installed, the screen would face up) for both...
thingiverse
Made this for a friend so we could flush mount it into his vehicles sun glass holder pocket. The gauge will prettymuch press fit into this bezel without anything holding it in. We used a dab of hot glue to make sure it never comes un done. Buttons...
thingiverse
This is a mount to place for example this Ultragauge beside the original revmeter of an mini cooper(s) R50/R53. ... Instructions I printed it sideways with suport material.
thingiverse
Halterung für Ultragauge für den Mini R56 Kann mit den Standardschrauben vom Drehzahlmesser befestigt werden. ...Am Halter selbst ist dann eine Bohrung um das Ultragauge mit einer Schraube fest zu machen.
thingiverse
The original (flimsy) clip for my UltraGauge (automotive ODBII display) broke. Here's my replacement. Instructions Download, Generate GCode, print. Clean up with Dremel or Xacto knife as needed.
thingiverse
This is a replacement bracket for the Ultragauge OBDII monitor. The one that comes with the gauge can break pretty easily. Edit: I needed to reprint using ABS as PLA warped in a hot vehicle. This took me a few revisions but I finally got it...
thingiverse
A simple holder for the Ultragauge for a second generation Mini, in this case an R60 (RHD !). The holder is using the lower 2 screws and re-uses the clip that came with the Ultragauge. ... I found you will need to use 2 slightly longer screws, I...
thingiverse
http://www.thingiverse.com/apps/customizer/run?thing_id=536645 Instructions Using the following options: mount_tube_dia = 11 mount_wall = 3 nut = 5.5 servo_flange_width = 35.0 mount_angle = 80 screw = 3.0 servo_flange_height = 20.0 mount_tube_dist =...
thingiverse
... The base is designed to be applied with Gorilla double sided tape, and the top mount slips into the T-Slot on the back of the stock UltraGauge holder. Hardware required is an M5x0.8mm nut and bolt. Please feel free to change this as you wish.