5 axis maker 3d models
642210 3d models found related to 5 axis maker.thingiverse
Small, simple mod for Z-axis endstop in JG Maker A1 (JG Aurora A1) It's working like rising the endstop in the range of 2-10mm (different models) Fits under the right Z-axis motor (wider side in) and should stay in by itself (if it's too loose print...
thingiverse
The Monoprice Maker Select has an annoying habit of its Z Axis motors getting out of alignment which creates the illusion of the build platform needing to be calibrated. Apparently this occurs when you turn off the printer and the motors release...
thingiverse
+ approx 470-480mm SS 8mm smooth rod + 5 x M3 hex nuts + 5 x M3x12 pan head machine screws My friend who owns this printer wanted the probelm corrected and I suggested a new carriage with wider wheel base and replacing the four T profile extrusions...
thingiverse
I was rebuilding my Maker Select V2.1 and realized that I could move the x axis forward and backward by about 3mm. Which is bad, and the only way to tighten it was to tighten a grub nut that was behind a metal plate, a bar... and several other pieces...
cults3d
I was rebuilding my Maker Select V2.1 and realized that I could move the x axis forward and backward by about 3mm. Which is bad, and the only way to tighten it was to tighten a grub nut that was behind a metal plate, a bar... and several other pieces...
thingiverse
For best results, drill out the rod holes to 5/16" or 8mm and drill out the acme screw hole to 1/4". Apply a little bit of grease to keep it quiet. In the comparison picture, top left is before brace and bottom right is with brace. You may...