divmmc enjoy enclosure sinclair zx spectrum 3d models

I don't like very much flying saucer designs, but I really enjoyed the show. The bottom part may require support. <br> The file's names explained: <i>name_1_x_10_y.stl</i> is 1 : x * 10^y. So _1_6_10_7 is 1:600000000 or one in 60...

Enjoy!Just a few tips on settings. The Dragon hotend does not need as much retraction as stock Qidi. I find around 0.8-1.0 mm is good with a retraction speed of 25 mm/s, depending on filament. If you get blobs on layer changes, disable "travel prime"...

Enjoy!Just a few tips on settings. The Dragon hotend does not need as much retraction as stock Qidi. I find around 0.8-1.0 mm is good with a retraction speed of 25 mm/s, depending on filament. If you get blobs on layer changes, disable "travel prime"...

... This was one of my favorite prints so far, and one of my easiest (and no supports). If you have any trouble printing, or need some additional support, drop me a line or leave something in the comment section. Please enjoy &amp; leave a comment!

Enjoy!Notice: You may need to remove the dial holder while printing else it could hit the frame of the printer. On the X-Max you can have it installed all the time but I'm unsure of the other supported printer models.</i></p><p><strong>Just a few...

350–340 BC) showing Cadmus fighting the dragon of Ares[104] In the founding myth of Thebes, Cadmus, a Phoenician prince, was instructed by Apollo to follow a heifer and found a city wherever it laid down.[105] Cadmus and his men followed the heifer...

Enjoy!Just a few tips on settings. The Dragon hotend does not need as much retraction as stock Qidi. I find around 0.8-1.0 mm is good with a retraction speed of 25 mm/s, depending on filament. If you get blobs on layer changes, disable "travel prime"...

Enjoy!Just a few tips on settings. The Dragon hotend does not need as much retraction as stock Qidi. I find around 0.8-1.0 mm is good with a retraction speed of 25 mm/s, depending on filament. If you get blobs on layer changes, disable "travel prime"...

Enjoy!Notice: You may need to remove the dial holder while printing else it could hit the frame of the printer. On the X-Max you can have it installed all the time but I'm unsure of the other supported printer models.</i></p><p><strong>Just a few...

Enjoy!Just a few tips on settings. The Dragon hotend does not need as much retraction as stock Qidi. I find around 0.8-1.0 mm is good with a retraction speed of 25 mm/s, depending on filament. If you get blobs on layer changes, disable "travel prime"...