in dash iphone dock 3d models
1759357 3d models found related to in dash iphone dock.grabcad
iPhone on Dash. ...Made of Polyurethane (50-60 Shore A)
thingiverse
This is a derivative of the OpenJSCad iPhone 5 dock, sized to fit an iPhone 6 and the lightning connector. Just like the iPhone 5 version you probably have to sacrifice a lightning cable by cutting the strain relief to allow it to flex enough to fit...
thingiverse
The jscad has configurable parameters for: margin around the iphone (for if it is in a case) margin around the dock connector: 0.25 mm gives a tight fit in my case (RapMan at 0.25 layer height) to add a mouse ear at one end, to prevent warping You...
thingiverse
This is a derivative of the OpenJSCad iPhone 4 dock, sized to fit an iPhone 5 and the lightning connector. Instructions See the parent thing for details on how to use OpenJSCad if needed. ... Some minor...
thingiverse
My radio connects to the phone but I wanted an easy way to dock it when I get in the car. Now I just drop it in. Print Settings Printer Brand: Deezmaker ...
thingiverse
... improvements on snap fit for phone and back fitment for vent. ...Holds the phone at a better angle to view while driving. A simple clip for your dash vents to hold a phone. This model is specific to VW GTI (2015+) - and Iphone 8Plus in Otterbox case.
thingiverse
I replaced the ashtray in the centre of the dash with this holder that I designed for an iPhone 4 in a HEX wallet. The holder has a slot in the base for a USB / iPhone connector which plugs into a rear USB slot in the stereo. This set up gives you...
thingiverse
I wanted to design a case to mount on the dash of my truck that would feel like it was at home in my favorite sci-fi movie, and would also allow me to use it like a dash cam, as well as with apps like Spyglass. It is designed to hold an iphone 5. The...
thingiverse
iPhone charging dock for AlzaPower Lightning USB cable: https://bit.ly/2vbzYQB
thingiverse
Instructions Be prepared to donate an iPhone cable to this project. Feed cable through back of dock. Plug cable into phone. Apply glue to exposed surfaces of plug. Fit phone and plug into dock and align vertically.. ...Allow glue to set completely...
thingiverse
Simplistic dock for the iPhone 4 & 4s. Instructions Insert you cable in to the hole provided. ...You need to insert the USB end in to the top of the hole and bring through the base and lead cable long cable channel on bottom.
thingiverse
I used Chris Mcentee's (https://www.thingiverse.com/thing:2740465) iPhone 8+ car mount design for my own iPhone 8 car mount design to use in my 2018 Chevrolet Sonic. This is my first attempt at creating a 3D printable item. I used Tinkercad to...
grabcad
The iPhone's main attraction is its simple and minimalistic design. I felt the dock should reflect that too. ...So here's my first contribution to the contest !
myminifactory
This is a desktop dock for an iPhone. the hole in the bottom was designed to fit a lightning cable. I have a pretty big a case and i designed the dock for that so if you use your phone without a case it may cause problems. It was designed in a way...
thingiverse
The dock locks the iPhone in place and a lever at the back unlocks and then undocks the phone, straight out so the connectors are not damaged. The rubber covers of the lightning and headphone jack are gone from my griffin case, having broken off from...