string puller 3d models
19197 3d models found related to string puller.thingiverse
Guitar string puller, designed on TinkerCad. Easy to use tool, good to have handy when changing guitar strings. ...Easily slips under each string, and with a little bit of leverage from you, can stretch out the new set of strings.
cults3d
The item in question is the puller thing that goes on the end of a window blind string. Nothing too special, but functional. I know I have one of these that was accidentally broken (kid; dog; horse; bulldozer,) the story does not matter… but I...
thingiverse
Can be used with (hopefully) any round string Very easy to print, very easy to use Printed in PETG, not tested in PLA yet, but should work out fine, about 15-18 minute print time For how to use the tool, please use the photos as a guide, and feel...
thingiverse
A thing to mount to a circular servo horn to help it pull a cable. Instructions Derived from this guy's jawn: Servo wheel 4.0 by obijuan http://www.thingiverse.com/thing:19940 I just made this for...
thingiverse
This is a cable puller I designed to pull a cable through 1/8" Air brake tubing or 1/8" nylon tubing. I am using .050" weed whacker line from hardware store with this servo winch to pull fingers on a mechanical hand in a remote location. The pulley...
thingiverse
With these settings the string should break way before the print does (though be a bit careful with the tamping tool on top, that is vulnerable. On the bottom is a hexagonal bit opening to allow you to attach it to a drill to load the string. ...
thingiverse
Wanted a faster way to pull cables in drop ceilings, This "String Flinger Crossbow" will shoot a fishing line across the room, upwards of 75+feet at a time. Tie the cable to the fishing line once it is shot across the room to the pulling point of...
thingiverse
This is an extended "puller" for the flying helicopter toy http://www.thingiverse.com/thing:1885007/ I printed the helicopter at 50% size and the puller was a bit short. ... This puller is sized for 50% of the original.
thingiverse
puller made with solidworks bolts not included also id love to see a picture of one of these made and working
grabcad
Puller, actually a hanger for various mass weights, like the 4lb I had uploaded earlier. ...3d printed, works great and is light weight
thingiverse
Puller for size 80x35 mm. Need thing more screw M4x8 mm. ... Specification 001 - 1 002 - 2 003 - 1 004 - 2 005 - 1 (14 mm) 006 - 1 (22 mm)