ultius 3d models

I have made many new parts for my Tantillus, which I now call an Ultius, and had to remove the upper corners many, many timers. It was really tedious having to do it in a certain sequence, so I quickly cut away pieces with my Dremel. ... This is...

I call it an Ultius, as it sort of ended up looking and working bit like an Ultimaker, so Tantillus + Ultimaker = Ultius :) Z-Height When using an E3D Volcano I have around 12cm of Z-height! If you use J-head or normal E3D you are going to get...

Print in ABS to make the pieces heat-resistant if you plan on creating a heat-chamber, as PLA likes to go soft at around 50c You might want to take a look at my Tantillus (Ultius) lead-screw Z-axis - complete for further optimizing the Tantillus. My...

In addition you need 0,8mm normal spacer/shim with 8mm center hole and 16 outer diameter.Recommendations I recommend you take a look at my Tantillus Compact Ultimaker Slider Adapters Also recommend looking at my Tantillus (Ultius) lead-screw Z-axis -...

Needed a good endstop for my new Tantillus Z-axis and found Really High accuracy adjustable Z Endstop for Prusa which I remixed to Work for my purpose. I can't really remember the changes I did exactly, but I did away with the metal rod part. ...Print...

After designing the Tantillus Compact Ultimaker Slider Adapters I needed some new Endstop holders to use, so here they are. Print Settings Printer Brand: Ultimaker ...

I needed to raise the bottom a tad to make room for cables etc. in order to maximize my Z-height to 120mm even when using E3D Volcano hotend, which is very long and heated bed. ...Print Settings Printer Brand: Ultimaker ...

Simply wasn't room for the original fan-Mount when mounting ramps on the inside of the case and using my z-stage as well. Changes I lowered the entire part by 5mm and also resized the "side-wing" as they would otherwise touch the mosfets. What you...

--- The carriage is for use with the old Tantillus or my new Ultius build,which is a complete rework of everything. Relized it sort of felt like an Ultimaker, when I got well underway, so combined the names to Ultius. I made this carriage as I...

Needed some fans for my E3D Volcano hotend in my Ultius (Tantillus) printer. They are made to use 30mm fans as I do not have a lot of room in my Ultius printer. The fan-shrouds are just mirrored. Left and Right denotes the side when looking in at the...

--- As I modified my Tantillus I realized it worked just like an Ultimaker, and since I literally have changed everything I named my build Ultius. They use the standard 17mm spacing between XY rods' center. These XY ends are the effort of...