thrust stand 3d models
242820 3d models found related to thrust stand.
thingiverse
Testing was conducted on the Drone Propeller Thrust Tester (test results below). This part was printed with a slow setting, utilizing a 0.2 extruder nozzle at 0.04mm layer height. A Precision Knife was used to deburr and clean the print. Following...
thingiverse
All testing was done on the **Micro Drone Propeller Thrust Tester**, and test results can be found below. The print was done slowly, using a nozzle of 0.2 millimeters at a layer height of 0.04 millimeters. I deburred and cleaned the print using a...
thingiverse
All rigorous tests were conducted on the Drone Propeller Thrust Tester, a state-of-the-art device available online. The part was precision-printed at a slow speed using a 0.2 Nozzle with a layer height of 0.04mm. A versatile X-ACTO Knife was used to...
thingiverse
Testing was conducted on the **Drone Propeller Thrust Testing Jig**, and results can be viewed below. Printed with precision, the part utilized a slow speed print setting, featuring a **0.2 extruder nozzle** at 0.04 layer height. Once printed, it...
thingiverse
I built and tested it on the Drone Propeller Thrust Testing Jig, which yielded impressive results that can be seen below. The part was printed slowly with a 0.2mm extruder nozzle at 0.04mm layer height. A Precision Knife helped me clean up the...
thingiverse
I successfully designed the drone propeller with the **Drela AG10** airfoil coordinates and tested it on the **Micro Drone Propeller Thrust Testing Jig** (test results below).\r\n\r\nThe part was printed slowly, utilizing a **0.2 nozzle** at 0.04...
thingiverse
All tests were performed on the Drone Propeller Thrust Testing Jig (all results below). I printed this part with a slow setting, using a 0.2mm nozzle at 0.04 layer height. I deburred and cleaned the print with an X-ACTO Knife. After that, I...
thingiverse
All experimental testing was conducted on the **Micro Drone Propeller Thrust Tester**, which can be viewed below. A part was printed at a slow speed using a **0.2 nozzle** with a layer height of 0.04mm. After printing, the propeller was cleaned with...
thingiverse
In my case, I had a rocket body with a thrust vectoring nozzle that could be controlled just like it would be in real life. It could tilt in two axes and apply different amounts of throttle to vary the force being produced. Also, noise was added to...
thingiverse
This is a replacement battery hatch / cover for the Max Thrust Riot or the ArtTech Devil RC model aircraft. The original hatch is curved to match the profile of the fuselage, but in order to make it simpler to print and to limit the amount of support...
thingiverse
This is a small test rig I built to measure the thrust generated by 3D-printed propellers. Check out the pictures for a general idea of how it comes assembled. I used some M8 bolts, washers and nuts to hold the main assembly together. The smaller...